Fault Indicator
-
JYL-KK type fault indicator
The "energy module" which use the anti-corrosion and high-permeability material with low-power system design enables the battery-free full-function operation at a primary current of 5A$ 0.00Buy now
-
DYX-KK type fault indicator
The ring network cabinet online monitoring equipment is mainly suitable for the automation transformation of the traditional ring network cabinet and the switchgear. While realizing two remote (remote signaling, telemetry) functions, detect and locate the position of short circuit and ground fault at the same time, shorten the power outage time and scope. Not only is important for improving the re$ 0.00Buy now
-
JYW-KK overhead signal type remote fault indicator
Be the first to apply Roche coils into this type of indicator, It has great linearity of test data and is not affected by wire diameter, thus guarantee test accuracy;
The "energy module" which use the anti-corrosion and high-permeability material with low-power system design enables the battery-free full-function operation at a primary current of 2A$ 0.00Buy now
Hot Products
Contact Us
-
11KV switchgear metal clad power switchgear MV switchgear panel
KYN28 metal clad switchgear,
Knkong、ABB or Schneider inside
3.6-24KV, three-phase, AC 50/60Hz
Can be equipped with VS1 VD4 3AH5 ZN65A VB2 VCB
Meets IEC standard
Send us your SLD (Single Line Drawing) or requirements ,we design switchgear plan for you2019-06-21 -
33KV switchgear panel, metal-clad MV switchgear power switchgear panel
KYN61 metal-clad medium voltage switchgear,
Knkong、ABB or Schneider inside
40.5KV, three-phase, AC 50/60Hz
Can be equipped with VS1-40.5 VCB
Meets IEC standard
Design switchgear plan as SLD (Single Line Drawing)2019-06-21
The fault indicator refers to a device installed on power lines (overhead lines, cables, and busbars) to indicate fault current.
Most fault indicators can only identify and indicate short-circuit faults by detecting the characteristics of the short-circuit current.
According to the application object, the fault indicator can be divided into three types: overhead type, cable type, and panel type.
We hope to get a bigger international market, please contact us to become one of our distributors, sincerely look forward to your joining.